Placing and filling a bottom fill FFG liner: A step-by-step guide

The FFG liner (Free Flow Gusset) uses a patented folding that lets the liner unfold on its own during filling. In a bottom fill setup, the product enters through the valve at the bottom of the container, which keeps the top of the container free and the filling process simple. We walk through the entire process of placing and filling a bottom fill FFG liner.

Watch instruction video

Placing & filling procedure

A bottom fill FFG liner transports liquid and paste-like products inside an IBC container (Intermediate Bulk Container). Because the product enters from below and the patented folding does the work, this liner needs far less preparation than other folding methods: no filling bridge, no clamps and no operator holding the liner in place. What matters is the position of the liner before you start. We will walk through the process step by step, from placing the empty FFG liner to a fully filled container.

Step-by-step process

Step 01

Fold the liner over the front edge of the container

Place the liner in the container and connect the valve to the bottom fill connection at the front. Then fold the upper part of the liner over the front edge of the container. The fold keeps the liner open and keeps it clear of the filling area, while the valve connects to the filling installation at the bottom front of the container.

Step 02

Start filling: the liner unfolds by itself

Start the filling process. The product enters at the bottom and pushes the liner open from the inside out. From this point on, the liner needs no manipulation at all: the patented folding unfolds the liner into the container on its own, without putting stress on the film.

Keep an eye out

Watch the first litres, sometimes air in the piping system is blowing into the liner. If the liner does not open evenly, you can still correct it by hand at this stage. Once the container fills up further, adjusting becomes a lot harder.

Step 03

A fully filled FFG liner

Once the container is full, the liner covers the entire inside of the container and rests evenly against all four walls. Close the valve and disconnect the filling hose. The container is now ready to be closed and transported.

Download

Enter your email address and one of our specialists will contact you as soon as possible to send you the guidelines.

Conclusion

A bottom fill FFG liner keeps the filling process short and straightforward: place the liner, fold it over the front edge and let the product do the rest. The Free Flow Gusset design releases the trapped air and unfolds the liner into every corner, which gives you a clean, fast and reliable fill every time.

Qbig Packaging

Solid liquid solutions

Table of Contents

Free consultation from an expert?

Get in touch with our team to find the best liner setup for your packaging needs. We’re happy to advise based on your process, product, and performance goals.